Non working Macintosh IIci, IIsi and Performa 680CD

Seek advice, give advice or tell others about your repair and restoration projects

Non working Macintosh IIci, IIsi and Performa 680CD

Postby dan.c on Sun May 24, 2015 4:40 pm

Hi,

New to the forum - recently started collecting a few older macs. Have a few questions about a couple I have picked up that do not work.

The mac IIci and IIsi do not start at all - no lights, no fan, nothing. After opening them up i found the rom simms are missing from both of them. Will these prevent powering up at all, or will there be more issues? If that is likely the only issue anyone know where I could find the missing simms?

The preforma 680CD also has no signs of life - until you pull the logic board out. Then the fan, power light, hard drive etc all kick into life. Apparently it worked before being in storage for the last 10 years... any suggestions? I have left it plugged in for 24 hours in the hope of charging PRAM battery but no go.

have a few more that have issues too... but we'll leave those for another day.

Thanks
Daniel
dan.c
 
Posts: 1
Joined: Thu May 21, 2015 9:47 pm

Re: Non working Macintosh IIci, IIsi and Performa 680CD

Postby RonTurner on Tue May 26, 2015 2:10 pm

If a computer was working before being stored then that's a good start but electronic components age while in storage, there's also good storage and bad storage.
RonTurner
 
Posts: 339
Joined: Tue Dec 17, 2013 9:43 pm

Re: Non working Macintosh IIci, IIsi and Performa 680CD

Postby tezza on Tue May 26, 2015 4:15 pm

From memory mac IIci and IIsi model suffer from the leaky capacitor issue.

I'm not sure if missing ROM simms can prevent signs of powering up at all. They might. Electrolyte from leaky caps might as well. Check for signs of leakage around the caps and if seen clean up the area with isopropyl alcohol and cotton buds. That might help.
http://www.classic-computers.org.nz/blo ... lution.htm
Tez (Terry Stewart) (Administrator)
Collection: http://www.classic-computers.org.nz/col ... /index.htm
Projects and Articles: http://www.classic-computers.org.nz/blog/index.htm
Twitter: @classiccomputNZ | YouTube: Terry Stewart
Trade Me: tezza5
tezza
Site Admin
 
Posts: 2293
Joined: Thu Jan 01, 1970 12:00 pm
Location: Palmerston North, New Zealand


Return to Repair and Restoration

Who is online

Users browsing this forum: No registered users and 2 guests

cron