Sorry to take so long to reply!
- MFM hard drives and controllers
Apart from a jet engine-sounding Rodime brick, marked intermittent sector not found, no MFM drives left; sadly ISTRC also throwing out old Kalok octagon & early IBM? RLL drives much earlier.
That Rodime maybe 5MB is likely not really useable except as an artifact.
But I do have some few MFM/RLL controller XT boards, I think.
- any IDE hard drive below 500Mb - smaller the better
Ah, now, (after all this time, checking them out
- quite a choice!]
[Listed without prejudice, or intent to treat; - just a list, so far! ;=})]
[and I'm considering testing them, what it takes, & so forth ...
2x Seagate ST351A/X 40MB (stepper motor)
(jumpers for XT/AT operation)http://www.redhill.net.au/d/16.phphttp://support.dell.com/support/edocs/d ... 000003.htm
1x Seagate ST3144A 130MBhttp://www.redhill.net.au/d/123.phphttp://www.wonkity.com/~wblock/a4000hard/st3144.html
1x Miniscribe 8051A 40MBhttp://www.driveparameters.com/Miniscribe/8051A/http://www.redhill.net.au/d/14.php
1x Quantum ProDrive LPS 52AT 50MBhttp://www.computerhope.com/hdquantu.htm#prodrive
1x Quantum ProDrive ELS 127AT 120MBhttp://support.dell.com/support/edocs/dta/29278/
1x Quantum ProDrive ELS 210AT 210MB
1x Quantum ProDrive ELS 420AT 420MB
1x Conner CP30104H 120MBhttp://www.computerhope.com/hdd/hdd0060.htm
1x Conner CP30201 212MBhttp://www.computerhope.com/hdd/hdd0065.htm
2x Conner CP30254 250MBhttp://www.computerhope.com/hdd/hdd0052.htm
1x Conner CFS850A 850MBhttp://www.computerhope.com/hdd/hdd0025.htm
1x Fujitsu M2681TAM 264MB ATA2 Fast (256kb cache)
1x Maxtor 7120AT 120MBhttp://www.driveparameters.com/Maxtor/7120AT/
1x Maxtor 7540AV 540MB
1x Western Digital Caviar 140 42.6GB http://www.redhill.net.au/d/18.php
3x Western Digital Caviar 1210 212MB (128kb cache) (one noisy)
(other two have Win95 installs from note) (need to check what else)
- Normal CGA or EGA display
Sad to report I tossed a CGA a few years ago; I still have some EGA boards, not sure on CGA
- Monochrome 9 pin display (I have one working now, but it gets shared)
Ah well, now here's where it gets more interesting...
You might like this perfectly functioning item I spray-painted satin black from beige years ago, all dismantled to do so & even a green metallic spot for the on-off knob, & years later stored since seems still fine ... an Intra brand mono monitor:
front - off.jpg
lower front CU-sm.jpg
- My sanity
- 486 style AT case + PSU
A few of these but I doubt worth the freight I think.
Anyway, I'll see about testing some or all of the hard drives - let me know what you might be interested in.
The Intra monitor I had stuck on TM last year, to no interest - I'd be happy to see it go to a good home for a modest amount - what offer?