Page 1 of 1

TRS-80 model III - The Grafyx Solution installation?

PostPosted: Sun Apr 17, 2011 6:37 pm
by matsondawson
I need the wiring diagram for this board, or if someone has one installed, could they tell me what wires are soldered where?

Re: TRS-80 model III - The Grafyx Solution installation?

PostPosted: Mon Apr 18, 2011 10:42 am
by tezza
Matt,

I've received a document from John Benson, a contact in Australia which might help. I've emailed it it onto you. (I've just put this note in the right place!)

Re: TRS-80 model III - The Grafyx Solution installation?

PostPosted: Mon Apr 18, 2011 1:17 pm
by matsondawson
Thanks heaps it's all sorted now. The wire that was hanging out and goes to U17, this is an optional wire to hide artifacts during updates.