Page 1 of 1

Adding disk capability to a Sinclair QL to save software

PostPosted: Fri Jan 20, 2012 11:28 am
by tezza
This blog article on software rescue describes a project which was a direct spin-off from the Wellington meeting last weekend.

Many thanks Mike (acsi)!

Re: Adding disk capability to a Sinclair QL to save software

PostPosted: Fri Jan 27, 2012 1:30 pm
by mlasham
thanks for your article, I enjoyed reading this.
I have a couple of QL's with hard disk drives attached to them so I have not need to migrate to floppy drives.
That said, I've not turned them on now for about 8 years so I have no idea what condition everything is in :)

Re: Adding disk capability to a Sinclair QL to save software

PostPosted: Fri Jan 27, 2012 3:41 pm
by tezza
A Ql with a hard drive! Now that's a big step up from microdrives. What is the interface? Are they SCSI drives?