by SpidersWeb on Thu Feb 28, 2013 8:00 am
I'm in Wellington, and have had my fair share of IBM pops and bangs , if you/they wanted assistance.
First off they're just an IBM 5160 PC-XT in a box, with exception to the display, any details on the 5160 motherboard will apply here too.
There is a chance it'll just work but the common things are:
- line filter caps in the PSU - not necessary for operation but make lots of smoke and a loud bang - this wont hurt anything - my 6150 didn't even blink when this happened (although I jumped like a girl). If these haven't blown already, it's very likely they will within the first second to 15 minutes.
- tantalum caps - if shorted the PSU wont start but if it DOES start and they're dry they'll explode like little flaming projectiles - once removed the PC will run - there are common caps which fail which can make repair easier - I've never had pops or removals cause problems.
Edit 3: if a tantalum launches itself, make sure it's remains don't cause a short on the motherboard
To test for shorts on the motherboard, basic resistance measurements can be done at the power connector. If you get 0 ohms between a + connection and ground - you know you'll need to remove some tantalum caps (I have spares btw if he wanted to replace dead ones). Generally though, just plugging it in will perform this test for you - if shorted you'll see the fan just 'nudge' a tiny bit rather than spinning up.
To test the power supply, remove it and connect it to a sacrificial motherboard (I have a 286 board I use), and maybe a hard drive - this is just to make sure it doesn't vomit out 30 volts or something - I haven't had this happen yet - but if you were being super careful and had the time it's a good practice. Good time to crack out the multimeter and check the voltages are in range too.
Personally I just plug them in and see what happens, but how careful you wish to be is up to you.
Unfortunately I'm unfamiliar with the display side of things as that is unique to the 5155, although I've found that IBM displays don't seem to suffer many problems if any, so chances are that part of the system will be ok.
If it has a hard drive fitted and you get it running, use Norton Calibrate (or similar) to perform a non-destructive low level format on the hard drive - often I get MFM units that have been sitting in garages for years, they work fine for 10 minutes then start losing data, so I get in their with my maintenance before they have a chance.
Sorry for the long post, I'm quite passionate about my IBM stuff lol
Edit: I just noticed your 'little free time' - in that case just plug it in - but as above, make sure he knows that a bang is quite likely.
Edit 2: if you can't get it to power up properly and don't have time I'm happy to take a look, I can make room on the workbench
Wanted - Dead or Alive - Reward $$$: Compaq Deskpro 8088 / 286 / 386 - IBM RT 6150/6151 parts - AT&T 3B2 parts
VC Twitter