Already shown this photo, self explanatory...
![Image](http://i901.photobucket.com/albums/ac213/blockypixelssoftware/apples_zps27b32332.jpg)
Here are some more, A few clones
![Neutral :|](./images/smilies/icon_neutral.gif)
in this lot
![Image](http://i901.photobucket.com/albums/ac213/blockypixelssoftware/apples2_zps90040d73.jpg)
You can see a missing space bar and badge, don't worry ,got them, "fell off"
There are some other Apples stashed around the place, you can never have to many Apples
![Razz :P](./images/smilies/icon_razz.gif)
UNISYS Kennedy Tape Drive Unit, and a couple of big ol' heavy Hard drives underneath:
![Image](http://i901.photobucket.com/albums/ac213/blockypixelssoftware/unisys_zpsdce308ef.jpg)
Got plenty of Cassettes and Tape Reels for it. The whole setup weighs quite a bit, took two people to
get it up on the table, lucky its got wheels now, cause thats one big tape deck !
Inside one of my System-80 interfaces, a board has been added, a switch at the back and a new printer socket:
![Image](http://i901.photobucket.com/albums/ac213/blockypixelssoftware/interface_zpsd369889a.jpg)
Looks like if you had a system-80 you mod'd it, then look at the chip piggy backing on the
added board, looks like when you run out of mod's you mod'd the mod ?
Had to get to a fuse in an Apple IIc 9inch monitor, not a task to be taken lightly:
![Image](http://i901.photobucket.com/albums/ac213/blockypixelssoftware/IIc_zps34f7b2e8.jpg)
Will have to put it back together now ! , had to remove 44 screws to get to the fuse
you could say the fuse wasn't in the most convenient location
![Smile :)](./images/smilies/icon_smile.gif)
The filter caps had cracks then subsequently shorted out when powered up, blowing the fuse,
replaced the filter caps and fuse, two more IIc monitors to do now
![Neutral :|](./images/smilies/icon_neutral.gif)
before the smoke comes out !
And the photo of it back together and working , who says the magic smoke coming out is the end ?
![Image](http://i901.photobucket.com/albums/ac213/blockypixelssoftware/monitor_IIc_zps3273ff98.jpg)
Not bad for two hours work !!! took awhile to figure out how to put it back together!